How to set osd scrub load threshold = 2.0

[kellogs]

Hello,

What is the best way to set osd scrub load threshold = 2.0 in proxmox ceph?

 

[Moayad]

You can set the scrub load threshold [0] as the following:

ceph config set osd osd_scrub_load_threshold 2.0

[0] https://docs.ceph.com/en/quincy/rados/configuration/osd-config-ref/#confval-osd_scrub_load_threshold

 

[kellogs]

Dear Moayad

Do i need to write in in the ceph.conf to make it persistent after reboot?

Do i need to execute this on each ceph node or 1 node is ok?

Thank you!

You can set the scrub load threshold [0] as the following:

ceph config set osd osd_scrub_load_threshold 2.0

[0] https://docs.ceph.com/en/quincy/rados/configuration/osd-config-ref/#confval-osd_scrub_load_threshold

 

[Moayad]

No not need to write in the ceph.conf and not need to do a reboot.

Do i need to execute this on each ceph node or 1 node is ok?

On a single node will propagate. However, you can run the following command on all the nodes to make sure that the scrub load did on all the nodes.

ceph config get osd osd_scrub_load_threshold

 

[kellogs]

No not need to write in the ceph.conf and not need to do a reboot.


On a single node will propagate. However, you can run the following command on all the nodes to make sure that the scrub load did on all the nodes.

ceph config get osd osd_scrub_load_threshold

Thank you so much Moayad