How to define an IP address for a VM?
- Thread starter tytowa
- Start date
Read the Provider setup quide.
He give you ip, a network mask, default gateway and so on.
then you have to setup nat, ipv4 forward and port redirect to you vm.
The ports form the proxmox pve gui you must setup a special way.
There are some information on the inet that can mat your setup:
* https://serverfault.com/questions/1104648/proxmox-on-hetzner-single-ip-routed-configuration
* https://community.hetzner.com/tutorials/install-and-configure-proxmox_ve/de
He give you ip, a network mask, default gateway and so on.
then you have to setup nat, ipv4 forward and port redirect to you vm.
The ports form the proxmox pve gui you must setup a special way.
There are some information on the inet that can mat your setup:
* https://serverfault.com/questions/1104648/proxmox-on-hetzner-single-ip-routed-configuration
* https://community.hetzner.com/tutorials/install-and-configure-proxmox_ve/de
Hello,
Assigning an IP to a VM is something that has to be done on the VM side. From Proxmox VE's side you can define a Linux bridge (You can think of this as a virtual switch, by default you should have one called `vmbr0`), and use that connect VMs to when you configure their network. See [1] for more info.
[1] https://pve.proxmox.com/pve-docs/pve-admin-guide.html#sysadmin_network_configuration
Assigning an IP to a VM is something that has to be done on the VM side. From Proxmox VE's side you can define a Linux bridge (You can think of this as a virtual switch, by default you should have one called `vmbr0`), and use that connect VMs to when you configure their network. See [1] for more info.
[1] https://pve.proxmox.com/pve-docs/pve-admin-guide.html#sysadmin_network_configuration