I sure this is not a PBS problem, but just asking my peers..
I have really high i/o delay in my pbs dashboard.
I have determined its the disk I have attached via iscsi.
Its (the iscsi stuff) low end and not the best setup, and I have accepted that.
But is it possible to make the i/o delay selective and not check these drives? Or is the idea kinda pointless, and just rest knowing that I at least know?
Just not at a place to be able to revamp the pipeline between the pbs server and the iscsi endpoints, would most likely take a total replacement of hardware.
I have really high i/o delay in my pbs dashboard.
I have determined its the disk I have attached via iscsi.
Its (the iscsi stuff) low end and not the best setup, and I have accepted that.
But is it possible to make the i/o delay selective and not check these drives? Or is the idea kinda pointless, and just rest knowing that I at least know?
Just not at a place to be able to revamp the pipeline between the pbs server and the iscsi endpoints, would most likely take a total replacement of hardware.