Hi there,
I am a complete newbie to proxmox but I'd like very much to try it.
I have installed it and all looks nice and shiny in the web frontend, however I don't seem to get the network config of the host right.
My /etc/network/interfaces is as follows (to allow for checking stuff like masks, I have masked not the last but the first digits):
Obviously the .19 ist the host's Ip whereas the .114 and following should be for the guests.
However whatever I do I end up with:
I also tried to create the bridge manually with brctl and ended up to be able to ping the additional IPs, but when I tried to SSH I ended up on the Host again, not on the guests :-(
This might be an easy one for you but I can't seem to get my head around it.
Also I am wondering what to do in the guests then: Do I only need to add a veth or also a venet?
Please help. Thanks!
southy
I am a complete newbie to proxmox but I'd like very much to try it.
I have installed it and all looks nice and shiny in the web frontend, however I don't seem to get the network config of the host right.
My /etc/network/interfaces is as follows (to allow for checking stuff like masks, I have masked not the last but the first digits):
Code:
auto lo
iface lo inet loopback
# device: eth0
auto eth0
iface eth0 inet static
address X.Y.90.19
# broadcast X.Y.90.31
netmask 255.255.255.224
pointopoint X.Y.90.1
gateway X.Y.90.1
auto vmbr0
iface vmbr0 inet static
adress X.Y.90.19
netmask 255.255.255.192
gateway X.Y.90.1
bridge_ports none
bridge_stp off
bridge_fd 0
up route add -host X.Y.103.114/32 dev vmbr0
up route add -host X.Y.103.115/32 dev vmbr0
up route add -host X.Y.103.115/32 dev vmbr0
Obviously the .19 ist the host's Ip whereas the .114 and following should be for the guests.
However whatever I do I end up with:
Code:
/etc/init.d/networking restart
Running /etc/init.d/networking restart is deprecated because it may not enable again some interfaces ... (warning).
Reconfiguring network interfaces...Don't seem to have all the variables for vmbr0/inet.
Failed to bring up vmbr0.
done.
I also tried to create the bridge manually with brctl and ended up to be able to ping the additional IPs, but when I tried to SSH I ended up on the Host again, not on the guests :-(
This might be an easy one for you but I can't seem to get my head around it.
Also I am wondering what to do in the guests then: Do I only need to add a veth or also a venet?
Please help. Thanks!
southy