Hardware config for ProxMox

[Mattybbg]

Hi all, first time poster, I not sure if this is the right place but I have a question about the hardware setup for my Proxmox box.

This is a home server, and I'm limited to 4 SATA ports and 2 M.2 slots on the mobo. the config I want to use is:
1x 120GB NVME drive for Proxmox install on one M.2.
1x 500GB NVME drive for Virtual Machines on one M.2.
4x4TB drives as a storage pool on the SATA ports.

Does/will proxmox have any issues installing to and recognising and using the NVME drives in this setup?

Thanks in advance.

 

[Stefan_R]

If the M.2 drives are compatible with your mainboard, then they should be recognized without issue.

Keep in mind that some boards with 2 M.2 slots have one of them connected to the chipset instead of the CPU - not an issue per se, but might limit your throughput/latency for some higher end NVMe SSDs.

Best consult your mainboards manual for info on that.

 

[Mattybbg]

Hi Stefan,
thanks for the quick response, good point Re: throughput i will check that out.
Thanks.