First off I'm very new to Proxmox and Linux, so I apologize if I'm making any stupid mistakes.
I have followed multiple guides (one of them being https://www.reddit.com/r/homelab/comments/b5xpua/the_ultimate_beginners_guide_to_gpu_passthrough/) and initially got it working on a fresh windows 10 install, but the problem came once I tried ran a nvidia geforce update and reduced the number of cores available to system and rebooted. The spinning wheel freezes after about 3-4 seconds on the screen below:
Once this happened I tried using the windows start up repair, which was unsuccessful. So i tried to boot in safe mode instead and it worked here after it tried to undo some changes first:
Here is my
All i want is a full gpu passthrough experience so I can ran simulations remotely off a VM, I suppose once i got this in a running state again I will create a snapshot so I don't lose it again.
I have followed multiple guides (one of them being https://www.reddit.com/r/homelab/comments/b5xpua/the_ultimate_beginners_guide_to_gpu_passthrough/) and initially got it working on a fresh windows 10 install, but the problem came once I tried ran a nvidia geforce update and reduced the number of cores available to system and rebooted. The spinning wheel freezes after about 3-4 seconds on the screen below:
Once this happened I tried using the windows start up repair, which was unsuccessful. So i tried to boot in safe mode instead and it worked here after it tried to undo some changes first:
Here is my
/etc/pve/qemu-server/106.confAll i want is a full gpu passthrough experience so I can ran simulations remotely off a VM, I suppose once i got this in a running state again I will create a snapshot so I don't lose it again.
