Hello, I'm very, very new to Proxmox. I originally wanted to use ESXi, but I learned my CPU is too old for v7.0 so I turned to Proxmox VE instead.
I put a fresh install of Proxmox on a home server I have and it goes through the installation just fine. But, when first booting it up, it prints some things on the screen, ending with "ipmi_si dmi-ipmi-si.0: Could not set up I/O space" before I get a No Signal message from my monitor indefinitely.
I was wondering if anyone knows of possible reasons as to why this is happening and how I could fix it? I've tried searching this error and I can't find much information.
My specs are:
(Attached is an image of my monitor with all that it prints out before it goes completely dark)
I put a fresh install of Proxmox on a home server I have and it goes through the installation just fine. But, when first booting it up, it prints some things on the screen, ending with "ipmi_si dmi-ipmi-si.0: Could not set up I/O space" before I get a No Signal message from my monitor indefinitely.
I was wondering if anyone knows of possible reasons as to why this is happening and how I could fix it? I've tried searching this error and I can't find much information.
My specs are:
- Intel Xeon X3450 CPU
- Supermicro X8SIE-F motherboard
- 16GB 1333MHz DDR3 ECC RAM
- 2x 500GB HDDs (where I installed Proxmox), 1x 750GB HDD
(Attached is an image of my monitor with all that it prints out before it goes completely dark)
