[SOLVED] FJ Eternus DX200 iSCSI Base volume - empty

[mishki]

Hi
There is Proxmox 6 and Fujitsu Eternus DX200.

Is it possible to somehow connect them to each other ?.
Proxmox adds iSCSI from the DX200 to the 'Storage' list,
but when trying to create LVM it cannot see 'Base Storage' and create a disk. (CHAP is OFF)

Is this due to some settings or restrictions from the FJ Eternus DX200?
Is there a way to work with the DX200 + Proxmox? (Could be another way?)


ps. The problem has already been described, but with other devices and other sources of the problem

 

[LnxBil]

If you want to use iSCSI as a backing device with LVM and have multipath, you need to setup everything manually.

I've never used Eternus with iSCSI before, we always exclusively use FC, but the setup is similar and the multipath setup can be found here.

 

[mishki]

If you want to use iSCSI as a backing device with LVM and have multipath, you need to setup everything manually.

Yes, manually is good, but..

I've never used Eternus with iSCSI before, we always exclusively use FC, but the setup is similar and the multipath setup can be found here.

Before connect to Eternus - I forgot to add Proxmox IQN Name ( /etc/iscsi/initiatorname.iscsi) and IP Name in iSCSI host group..

After that all is well..

 

[LnxBil]

Perfect! That's for reporting back.

 

[nejcl]

Hello,

could you please explain it a bit more, I have a similar issue, I was able to add Eternus as iSCSI storage, but I am unable to see any Content in view. I have configured Lun group and all.

Proxmox 6.2-15

 

[mishki]

Hello,

could you please explain it a bit more, I have a similar issue, I was able to add Eternus as iSCSI storage, but I am unable to see any Content in view. I have configured Lun group and all.

Proxmox 6.2-15

1. Check your ETERNUS - Port/Host/LUN Groups. I use iscsi and 3 proxmox hosts:

 

[mishki]

2. I have problem with multipath, but they were solved too
it is russian forum, use translate.google.ru

problems and solutions:
https://www.linux.org.ru/forum/admin/15721218?cid=15752130
https://www.linux.org.ru/forum/admin/15721218?cid=15721747

multipath worked for me, only after the command for each disk:

multipath -a /dev/xx

 

[mishki]

3. for the initial setup (rather for visibility) I used webmin. node 1-4 - ETERNUS.

 

[nejcl]

@mishki thank you very much. This solved my problem.

Thank you for your time.