Errors after VM reboot.

[chaddyle]

First off, I am very new to this and have been watching YouTube videos and reading PROXMOX posts. I can’t seem to get around this error and would really appreciate some help. The only way that I can get into the Win 11 VM is to go into the BIOS and select “UEFI QEMU HARDDISK QM00013” from the options, it will immediately boot into my Win 11 install. If I reboot the VM, it will generate the following errors.

It gets stuck on “Start PXE over IPv4”.
The error after this is “failed to load Boot0003 UEFI PXEv4”
I have tried to rearrange the boot order by making HARDDISK QM00013” the first one, but it never stays after I save and exit. I have also turned off the Secure Boot option.

Again, any input would be greatly appreciated.

 

[Impact]

What do the VM's Hardware and Options tabs look like?

 

[chaddyle]

Here are screenshots of those two windows.

 

[Impact]

Go to Options > Boot Order and add sata0 at the top.

 

[chaddyle]

That did it. I didn't realize that I had to change that there. I did it in the BIOS, but it would never stay. Thank you very much. Next up, getting the ARC380 to pass through for PLEX.

 

[Impact]

I have some tips for that too

 

[chaddyle]

I'd love to hear them. Any tips, references, or videos, I'll take them all. I'm using it for the Plex server. I didn't know if I should run Plex inside of Win11 or a container. I've never tried it before. I built my son a new computer and used his X99 motherboard to cram an 18-core Xeon in it. Just trying to see how much I can get out of it.