Check of pool satassd/data failed

[mn124700]

Hi everyone. I'm getting an error message when I try to create a VM: Check of pool satassd/data failed (status:1). Manual repair required!

I tried running lvconvert --repair pve/data. However, this gives the error: Active pools cannot be repaired. Use lvchange -an first.

So, I ran lvchange -an pve/data. This appeared to succeed, and lvscan showed pve/data as being inactive.

However, re-running lvconvert --repair pve/data still gave the same error: Active pools cannot be repaired. Use lvchange -an first.

Running lvs -a shows that pve/data has 67% data and 4% meta.

Where am I going wrong?

Thanks much for any help. I'm fairly new at this.
Eric

 

[Moayad]

Hi,

Where am I going wrong?

Maybe there is still some active I/O on the logical volume? Can you check using `lsof /dev/mapper/pve-data` command?