Can't get Broadcom BCM57414 NetXtreme-E 10Gb/25Gb Nics to work at 10Gb/s, or anything over 1Gb/s. Running in a Dell PowerEdge R640 connected to a Dell S5224F-ON switch. I've installed drivers per Broadcom's instructions. I've toggled MTU settings. Same cards work in our VMware environment using the same model switches on same model of servers. Any help is appreciated.https://techdocs.broadcom.com/us/en...ce-drivers-using-the-automated-installer.html
ethtool ens1f1np1
Settings for ens1f1np1:
Supported ports: [ FIBRE ]
Supported link modes: 1000baseX/Full
10000baseCR/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: RS BASER
Advertised link modes: 1000baseX/Full
10000baseCR/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 10000Mb/s
Lanes: 1
Duplex: Full
Auto-negotiation: on
Port: Direct Attach Copper
PHYAD: 1
Transceiver: internal
Supports Wake-on: d
Wake-on: d
Current message level: 0x000020c1 (8385)
drv rx_err tx_err hw
Link detected: yes
ethtool ens1f1np1
Settings for ens1f1np1:
Supported ports: [ FIBRE ]
Supported link modes: 1000baseX/Full
10000baseCR/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: RS BASER
Advertised link modes: 1000baseX/Full
10000baseCR/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 10000Mb/s
Lanes: 1
Duplex: Full
Auto-negotiation: on
Port: Direct Attach Copper
PHYAD: 1
Transceiver: internal
Supports Wake-on: d
Wake-on: d
Current message level: 0x000020c1 (8385)
drv rx_err tx_err hw
Link detected: yes