[SOLVED] After upgrade to v7.2 No network after a while

J

jobbsen

New Member
May 8, 2022
1
0
1
Solved:
I run the 7.1 version and waited for a newer version of proxmox

Made new installations of 7.1 and check if the nodes are okay after that i updated to 7.2-4 on
all the machines in the cluster and now it just works.. Thanks for nice proxmox


Hi Proxmoxers.
An Proxmox beginner here :)
Many thanks for Promox! its lovely.
Keep up the good work.

Problem:
I upgraded to Proxmox 7.2 from Proxmox 7.1 on my lenovo B50 laptop!
After a while the network stops and this messages comes up in the console.

proxmoxerror2.jpg
Error message:
r8169 0000:08:00.0 enp8s0: rtl_chipcmd_cond == 1 (loop: 100, delay:100).
r8169 0000:08:00.0 enp8s0: rtl_eriar_cond == 1 (loop: 100, delay:100).

I tried this: Reinstalled a clean Proxmox version 7.2 with same result.

Solution right now: Running Proxmox version 7.1 without any network-card problem.

Network-card information:
lspci output from Proxmox 7.1
08:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 10).

Any suggestions what to do with this?
 
Last edited:
Hi jobbsen,
I've the same problem right now, after upgrade to 8.0 from 7.4.
Have you found a solution better than stay on Proxmox 7.1?
 
Hi

same probleme here. today proxmod 7.4 to 8.0 , rtl_***** issue
no connection after some times
 
Instead of, i m testing r8168-dkms via APK. It's seems to be ok with proxmox 8

wait and see :)
 
You must log in or register to reply here.
Top Bottom