1Gbit nic = 100 Mbit speed negotiated

FuriousRage

Renowned Member
Oct 17, 2014
114
3
83
Hi.

I have a nic that is a GBit one, but it only negotiates 100 mbit.

This network card is connected to internet, that have 250/100 Mbit speed. no router or switches between the nic and internet. Any ideas how to get it to set Gbit?
I have tried ethtool -s eth1 speed 1000 autoneg off. But then i cannot get a link at all and ethtool eth1 says unknown on speed.
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
 
Hi.

I have a nic that is a GBit one, but it only negotiates 100 mbit.

This network card is connected to internet, that have 250/100 Mbit speed. no router or switches between the nic and internet. Any ideas how to get it to set Gbit?
I have tried ethtool -s eth1 speed 1000 autoneg off. But then i cannot get a link at all and ethtool eth1 says unknown on speed.

I'd double check that the internet device, modem I'd assume, has a gig nic. I've ran into a few areas where they buy 100+ speed, but have a 10/100 nic facing in..
 
I'd double check that the internet device, modem I'd assume, has a gig nic. I've ran into a few areas where they buy 100+ speed, but have a 10/100 nic facing in..

No modem.. FIOS connection.
Check all cables. they are either Cat 5e or Cat6.


EDIT: I changed cables from internet to server to a Cat6 labeled cable.. i can now ethtool -s eth1 speed 1000 duplex full autoneg on but i STILL only get 100Mbit :(
tomorrow i will swing by my work and fetch my work laptop and test its ethernet port directly to internet and see if speedtest still says 100mbit..
 
Last edited: