B
boca
Guest
Hi all,
I'm trying to setup my server so that I have 1 bridge per network card.
So what I've done is:
NIC1 (eth0): 10.3.3.200/24 - Gateway 10.3.3.1 - vmbr0
NIC2 (eth1): 10.3.3.210/24 - vmbr1
This works fine, and I can ping both 10.3.3.200 and .210 without any issues.
What makes me confused is that when I run a ping command against 10.3.3.210 and then unplug the network card from that interface, it still works? Which indicates that all traffic is still flowing through eth0 (10.3.3.200)?
My question is; How can I setup Proxmox to exclusively use eth0 for 10.3.3.200 and eth1 for 10.3.3.210? or is this not possible?
Thanks!
I'm trying to setup my server so that I have 1 bridge per network card.
So what I've done is:
NIC1 (eth0): 10.3.3.200/24 - Gateway 10.3.3.1 - vmbr0
NIC2 (eth1): 10.3.3.210/24 - vmbr1
This works fine, and I can ping both 10.3.3.200 and .210 without any issues.
What makes me confused is that when I run a ping command against 10.3.3.210 and then unplug the network card from that interface, it still works? Which indicates that all traffic is still flowing through eth0 (10.3.3.200)?
My question is; How can I setup Proxmox to exclusively use eth0 for 10.3.3.200 and eth1 for 10.3.3.210? or is this not possible?
Thanks!