“DXE--Legacy OPROM Initialization..”

[No0b]

I am trying to use Proxmox with an HBA for PCIe pass through (TrueNAS). I configured the BIOS according to this guide, got Proxmox to work, added my first two drives to the HBA, and could see and add data to them. After I added my remaining 4 drives, it outputs:

Asmedia sm1064/116X Sata Controller .....
Followed by the Supermicro Screen with;
“DXE--Legacy OPROM Initialization..”

This is where it gets stuck. I have tried to get in BIOS at this point, to no avail. I can boot Proxmox if I remove the HBA.

H11ssl - NC
EPYC 7302p
64 GB ECC RAM
2 * Boot drives 250GB
6 * 10 Sata TB drives
HBA: https://www.amazon.ca/Controller-Expansion-Profile-Bracket-Interface/dp/B085NQVHLQ

AMD IOMMU is on.
Secure Boot is on.

Thanks for any help.

I have checked the following. I have not reset the BIOS.

1. https://www.supermicro.com/support/faqs/faq.cfm?faq=33415
2. https://www.reddit.com/r/Proxmox/comments/16rvzmq/proxmox_wont_boot_with_hba_card_installed/

 

[No0b]

After booting into Proxmox, ata24.00: failed to enable AA (error_mask=0x1)

 

[No0b]

Appears to be Hard Drive Issue.