vlan gui

  1. J

    Proxmox 9.1 and vlans stopped working.

    Hello proxmox community, does anyone have any info on getting trunked vlans working in 9.1? Here is my issue: I installed proxmox 9.1 everything went smoothly with the install. This is on a dell server with multiple nics, all on vlans and the primary access is on a trunk port. The installer does...
  2. D

    [SOLVED] VLAN works form host itself but not on VM

    Hello Forum I have searched the forum for an answer for about a month now, but I am unable to find one, or a similar solution to my problem. Recently I made the decision to migrate to Proxmox as hypervisor after using VMware since 2012. It goes very well. I’ve got an LXC container running and...
  3. J

    [SOLVED] No networking on VM in same PVE management VLAN

    Hi, as the title says i'm having a problem on VMs and containers that share the host pve VLAN. If the VM goes on a different VLAN, no problem. My intention is to have a bond between eno1 and eno2 with lacp layer 2 and have one bridge so every VM goes through that bridge with the specific VLAN...
  4. M

    VLAN in GUI

    Dear. It will be a good choice to add a native support for VLANs in GUI for : Linux native interfaces (LAN card, Bond, Bridge) For now it is possible to use it, by manually modifying: /etc/network/interfaces, but it will be much better in GUI (with syntax check) In OpenvSwitch it is...
Top Bottom
Back