trunk trunks vlan vlans network vmbr

  1. J

    Pass trunk to VM

    I want to set up a trunk on my switch and create a bridge in Proxmox that I can assign to a VM. Within the VM, I want to be able to treat the interface as though it is directly connected to the switch, with the trunk available. Then I want to be able to create sub interfaces on the VM on...
  2. B

    Proxmox trunk with palo alto sub interfaces

    Hoping someone can help me with this, I have been struggling for a couple days now. I have proxmox 8.1.4 setup with 2 x 1 gb ethernet ports connected to a cisco switch and 2 x 10gb dac ports connected to a brocade. 1 10gb port is set as a trunk on the brocade which is connected to enp8s0f0 in...
  3. A

    [SOLVED] Dose PVE support guest access to trunk topology?

    Hello, And: I got: A PVE Cluster, A Managed Switch, And an access port from Core Switch ( That's the point, vlan and turnk will only exist in my private zone). I want: - Access PVE WebUI in vlan A - Put trusted infrastructure like ntp dns in vlan B - Put shared but trusted software (for dev)...
  4. L

    Config Network on Proxmox Plz Help me

    My config on switch My Config on Proxmox I can't ping gateway please help me ^_^
  5. N

    Passing Trunk to VM

    First let me explain my problem. I'm passing a trunk from my cisco switch to my Dell r710 over one ethernet cable, eno1 in Proxmox. I created vmbr with port eno1.10 and gave it an IP so that VLAN 10 on my network can reach Proxmox. However, it appears that when I create that tagged bridge, it...
Top Bottom