routing

I use proxmox for tinkering around with at home, and for remote access, I rely on an IPSec VPN that's setup through PFSense. When I connect through the VPN remotely, I can access all the hosts on the local network, (i.e., router, DNS, my desktop, file server, etc, etc) However, I CAN'T access...

-

Hello, I've got a strange issue. My Proxmox 4.4 server is connected to two networks: 10.10.1.0/20 and 10.10.16.0/24. I use a dedicated routed network (vmbr0, 10.20.1.0/24) for my VMs. A ping to the networks (10.10.1.2 or 10.10.16.2) from the Proxmox host is possible. I can partly access the...

Hi, I used to have my proxmox with one nic and a gateway to my ISP router (172.28.64.2) Nowadays, we have 2 internet providers, each with their own routers and different IP range. I added a second NIc to proxmox and what I want is to create some VM that will use this second nic and the second...

Hi All, I need help with routing on proxmox. I am trying to configure routing as shown in the diagram attached. I will start configuring the routing part later, but what i dont understand is how VMs in the 192.168.1.0/24 network are able to ping vmbr0 . I need to isolate them and make them...

So here is the setup I have. A single, public, proxmox server running version 4.1-22. It has a single NIC with a single public IP. And that is all I can get. So naturally I am using NAT behind that public IP for my containers. So on the physical host, Eth0 --> Vmbr0 /w public IP. In...

Dear community, I have two Proxmox 4.1 with latest patches and LAG (openvswitch) working. Both are attached to a Layer 2 switch. There is also a simple 1Gb Router with minimal vlan support, so I don't want to use the inter-vlan routing anymore, because the throuput is very, very low. Is it...

Hi to all , I have a cluster proxmox 4.1 with 3 nodes configured and functional. On one of the nodes I have a LXC container using a private routed network. The container can access the Internet and everything works fine. To access to this container from the other nodes I added the necessary...

Hi, I've just bought a dedicated server from OVH with Proxmox 4.0 (4.1-15/8cd55b52) installed. After doing the suggested updates and reboots I've created an LXC container (Debian 8) and assigne to it a Failover Ip from OVH. I'm following this guide https://pve.proxmox.com/wiki/OVH I've...

I have proxmox 3.4 with the following configuration for the net: auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 10.1.46.5 netmask 255.255.255.0 gateway 10.1.46.2 post-up echo 1 > /proc/sys/net/ipv4/conf/eth0/proxy_arp I want routing configuration and to...