routed

  1. S

    Routed mode with Bonding and VLANs - support needed

    Hi, I am trying to configure my Proxmox VE server to use Bonding, VLANs and make the VMs/CTs run in "routed" mode. I have successfully configured the Proxmox VE host to use bonding and VLAN on the host. However, I am currently stuck configuring vmbr0 interface for routed mode. I have used...
  2. M

    Proxmox VE 8 with Firewall in Routed Configuration. Netfilter POSTROUTING SNAT not working

    Hi, since switching to Proxmox VE 8 Postrouting SNAT (Unfortunately I must use NAT) in combination with the Proxmox Firewall is not working anymore even with conntrack zones enabled. In Proxmox VE 7 it worked after adding post-up iptables -t raw -I PREROUTING -i fwbr+ -j CT --zone 1...
  3. A

    Can't access to internet in my LXC container

    Hello everyone, I have installed a proxmox in version 7.4-3 and i have configure it. I have create LXC container and I have not outgoing on internet. I have follow the configuration on official website for "routed configuration" but this not working in my LXC container. This is my network...
  4. A

    Proxmox, routed mode with a block ip not working

    I have a problem with Hetzner in Routed mode since I have to apply a subnet to the server. According to your docs (one thing) and according to your support (something else) I have this setup. No matter how hard I try, I can't understand why it doesn't work, even more so when I see the routes...
  5. K

    what to do if my proxmox provider does not support the Default Bridge Configuration

    Hello, i have a proxmox server with a single ip addres and that's my correct network configuration : # network interface settings; autogenerated source /etc/network/interfaces.d/* auto lo iface lo inet loopback auto eth0 iface eth0 inet manual iface eth1 inet manual auto vmbr0 iface vmbr0...
  6. S

    Keine Internetverbindung in VMs

    Hallo liebe Community, ich wollte eine Routed-Netzkonfiguration einrichten und habe auf meinem Host die folgende Konfiguration eingepflegt: auto lo iface lo inet loopback iface lo inet6 loopback auto enp2s0 iface enp2s0 inet static address 1.2.3.4 netmask 255.255.255.224 pointopoint...
  7. M

    Hetzner Routed Config issue

    I have a dedicated server and a subnet on Hetzner, decided to use Network Configuration Hostsystem Routed config, was following their guide, https://community.hetzner.com/tutorials/install-and-configure-proxmox_ve Here's my server config: auto lo iface lo inet loopback iface lo inet6 loopback...
Top Bottom