management interface

Hello everyone, I'm a beginner when it comes to networks and servers, so I decided to buy an old server and install Proxmox to improve, I got an HP ProLiant DL160 g6 to which I added an additional NIC, leaving me with a total of 4 ports. After configuring Proxmox I decided to install a Sophos...

Hello I've added an additional network card into my proxmox computer. This causes a "device-rotation" (related to the network device names / numbers in proxmox) and a connection lost to the proxmox mgmt-ip. Old naming of the network devices (before inserting the new network card) was...

Hello. I am new to proxmox, not new to Linux though. I have a test proxmox server with 2 interfaces, one sits at the DMZ where some VMs will run exposed to the internet, another sits in the LAN. I wish to: 1. block any traffic from the DMZ completely (that is - hosts will be exposed, but I...

Dear colleagues, We have been using different virtualization solutions for over a decade. We have used XEN (the open-source project) on Debian since 2018. It is time to move to KVM, and we are considering switching to PVE, too. We have built much automation over the years, especially with...

Hello everyone, I am trying to configure a failover for the management interface and was wondering if someone could help me out. Below is how my configuration is now... auto lo iface lo inet loopback auto eno1 # this interface is the mangement interface for Promox web GUI iface eno1...

Hello! I've installed ProxMox with a Pfsense install where I have 4 network interfaces that are all natively passthrough (added as a PCI Device) to improve performance. I'd like to the make the gateway accessible on any of the LAN interfaces without using a Linux Bridge if possible. It was...

Hi, This is my first post on this forum, so please bare with me. I've searched the interwebz without finding an answer so thought I'd just test my luck here. Im configuring a new Proxmox hypervisor and I'm wondering about the proper way to Dot1Q the traffic going to the management IP of the...

Hi, I am looking to replace some ESXI hypervisors with Proxmox in light of the Broadcom acquisition, and I have to figure out how to make this work: I need to be able to access Proxmox from two separate networks, and both need to be able to say "Hey this traffic came in on this interface, send...

I have 2 networks in my server management and HA. I am creating a cluster which one should I use?

Hi Proxmox Community. I would like to report an issue I've been through since yesterday. Been banging my head ever since! I'm using 4 tagged VLANs between my Proxmox Baremetal Server (PVE 8.1.3) to my HPE Switch, VLAN 4 is my Production VLAN as well at the VLAN where I intend to access manage...