failed boot

  1. J

    PVE 7 to 8 upgrade gone wrong

    I have spent a couple hours on this already and haven't made it too far. I ran through the upgrade procedure and ultimately ended up with an error with apt. I figured I would reboot (I knew it was a bad idea). My server would not boot. There wasn't an entry in grub for the new 6.8.8-2-pve...
  2. N

    [SOLVED] Ubuntu 24.04 Container from official template fails to start

    Hi, I'm running the latest Proxmox with no updates available. I have downloaded the Official Ubuntu 24.04 temaplate by using the pveam command. I created a new conatiner using the template. It is installes fine and goes into runnig state. But when I open the Console there is no output at all...
  3. C

    update to 8.2.0: Reboot unmöglich

    Hi zusammen, ich habe aktualisiert. Reboot bleibt beim kernel load hängen. ich hab Reboot / Kaltstart versucht. Rescue Modus vom aktuellen / vorigen Kernel. Leider ohne Erfolg. Einer der Knoten bleibt tot. Einen weiteren Knoten kann ich nicht aktualisieren, da ich dann den Cluster...
  4. A

    [SOLVED] Web Proxmox, all LXC and VM's are down after update and reboot (PVE8)

    Hi everyone, After applying latest updates all of my containers, VM's and proxmox web instance are down. I've already done some research on Forums on what could help, but no luck there. Here are some logs and findings. I'm able to ssh to machine. I'm also getting ILO connection. :~# lxc-ls -f...
  5. T

    Proxmox fails to boot due to disc errors

    After recently rebooting my server Apollo power on again it fails to boot and enters emergency mode my disc configuration is: 2 SSDs in a zfs pool to make the boot drive. there is also a 3 terabyte hard disc for additional storage happy to give additional information but I don't have SSH...
  6. M

    lxc_init: 798 Failed to run lxc.hook.pre-start for container "xxx"

    hello i cant start my container after performing an upgrade on it with do-release-upgrade thanks i advance.
  7. M

    Failed to boot on HP Z820

    Hello everyone, I'm trying to install Proxmox on a HP workstation Z820 for learning purposes. The installation completes successfully however, when the computer restarts I get the following message: Non-system disk or disk error. No bootable device found. I have attached a picture of what I...
  8. M

    After installing on top of Bullseye hardware not booting

    Hello, after installing proxmox on top of bullseye, as not able to install form ISO, and then the server does not boot up and stuck. Anyone has any ideas why this happens or how to get over it ? it's on top of AMD, dont think I have seen this one before
Top Bottom