dhcp/pxe

  1. T

    VE 8.0.4: VM iPXE dhcp not working

    I'm using the latest Proxmox VE 8.0.4 and I'm trying to get the iPXE network boot to work. When I configure an VM with EFI bios everything works perfectly, but VM's with Seabios iPXE cannot get an DHCP address. The VM's both use the same bridge network. (vmbr0) I analyzed the network packets...
  2. S

    dhcp to assign whole /64 to each vm from a single /48 IPv6 block

    Hello! Is there any way using DHCP to assign /64 IPv6 block to each vm from a single /48 IPv6 block? Is there any way to achieve this? I did try everything but nothing works I am using same DHCP server to assign single IPv4 to vm and they work But when I try IPv6 nothing happen Here's the...
  3. A

    Firewall DHCP enabled

    For what needed option "DHCP enabled" ? I can setup any IPs on the VM with DHCP enabled and without.
  4. M

    Guest PXE on bridge device

    I am running a following setup Internet <-----[Gateway/VPN/Firewall/DHCP/PXE Host](192.168.1.1- <----------Proxmox Host(ip 192.168.1.30) The network is bridged with the device being vmbr0. I am trying to install KVM vms on the host but wheather i I try to use DHCP for PXE or boot using ISO...