cisco lacp bond bridge

Good Day All, I'm hoping that providing some context you can possibly help me resolve my issue. I moved my existing PVE install over to a Dual SFP NIC from a former 4x1G Copper NIC. After doing so I'm no longer able to access the host, as I've gone down a rabbit hole of configuration changes I'm...

Hi, I have more than 6 NICS in my server. Is there a possibility to create LINUX BOND for LACP at the installation stage or add it after the installation for vmbr0? I tried but it says the default gateway already exists on vmbr0. Any ideas on how to achieve this? Cheers,

Through ovs-vsctl, bridges from physical interfaces are configured in the GUI eno1 - Service NIC eno2 - Man NIC eno3 + eno4 - bond (LACP (balance-tcp)) Cisco shows the following error for server ports configured as bond: %EC-5-L3DONTBNDL2: Gi1/35 suspended: LACP currently not enabled on the...

Hello all, I'm having an issue with ProxMox and Cisco gear. The ProxMox server has a four-port ethernet NIC in an Open vSwitch LACP bond (I previously tried the built-in Linux interface config as well) to a Cisco 3560 Switch which then uplinks to a Cisco FirePower 1010 firewall. I have 5 VMs...

Hello guys, I recently decided to move my homelab ESXi 6.7 to ProxmoxVE. The basic Proxmox setup was pretty easy but now I am struggling with my network configuration. I have two VLANs: 10, LAN 20, DMZ My server has two network interfaces and both are connected with my Cisco SG250 switch. I am...

Hi forum! Ok, I know this one is old... but something has to be very wrong to be still happening: Hi have a single Node... no cluster. This node has 3 interfaces, one for Management, two for bonding. Switch is a CISCO Catalyst 3560g The setup is a typical, no-VLAN, bridging between bond0...