Hoping someone can tell me the obvious thing that I'm missing!
I'm running dual Chelsio T520-CRs in a Dell R620 with PVE 7.1. I have a pfSense VM on the host and am passing through the T520's.
All works fine if I pass through the whole card, but if I pass through an SR-IOV VF...
So I have a Chelsio T580-LP-CR NIC (2x 40gbps QSFP+ ports) that I'm trying to install the drivers of. I downloaded and unpacked the driver software, and since the PVE kernel is not supported officially by the software, I'm trying to make it from scratch. However, I'm encountering errors and...
I'm trying to passthrough a Chelsio T420-CR to a pfSense VM running on Proxmox version 6.2, but it's preventing the VM from booting. It gives this error:
kvm: -device vfio-pci,host=0000:83:00.7,id=hostpci1.7,bus=pci.0,addr=0x11.7: vfio 0000:83:00.7: hardware reports invalid...
I'm a newbie trying to use the native kernel driver for a Chelsio T520-CR 10GB ethernet card.
I'm getting this message on boot:
# dmesg |grep cxgb
[ 1.117913] cxgb4 0000:0e:00.4: Direct firmware load for cxgb4/t5fw.bin failed with error -2
[ 1.122854] cxgb4 0000:0e:00.4: unable...