bridge for specific nic

I have been trying to debug a weird issue with with a secondary NIC+bridge. I use a Mellanox ConnectX-3 10Gbit interface card for the secondary NIC. I am trying to set up two vmbrX pointing to two different NICs where both are on different subnet, the VLAN is handled at switch to make debugging...

Hi, i wasn't sure how to explain this.. but essentially, I have a proxmox machine with 5 NICs eno1 -> access port (vlan50) enp1s0f0 -> enp1s0f1 -> enp1s0f2 -> trunk enp1s0f3 -> access port (vlan 20) No matter what I try, I just cannot get any interface to work except for eno1. I created a...

Hi there, first time poster here, nice to meet you all. We are trying to run Snort as an NIDS in a Container on our Proxmox. We have dedicated NICs on our server for each container (theoretically) and a Cisco 3750-Series Switch that is connected to a different Switch (which we can't manage)...

Does anybody have recent experience (Virtual Environment 5.2-2) with using proxmox on scaleway baremetal? Seriously frustrated! Several issues that all seem to be network related: 1. Allocating vmbr0 to the eth0 nic stops the machine from booting up 2. Cant ping 8.8.8.8 3. CT's are not...

I located my own Hardware in a Data Center. Then I tried to setup bridged network for multiple VMs. The environment specified multiple IP addresses. First available IP address for my server is: xx.xxx.xx.194 IP Range is: xx.xxx.xx.194 - xx.xxx.xx.20x Gateway is: xx.xxx.xx.193 Netmask...

Hello, Lately I asked, on how to add a specific vNIC Model in VM configuration file, and the answer was with args, as the following: args: -net nic,model=pcnet balloon: 0 But I need to use bridge with it, I couldn't find anyway to add a bridge, I tried to follow the arg with bridge=vmbr2 but...