Search results

I clicked on NODE, went to System, Network clicked on Network Device (enp2s0f0, enp2s0f1), and changed the MTU to 9000 just remembering this device is configured as PCI PASSTHROUGH I rebooted the proxmox. when I give an ifconfig in the proxmox, 9000 appears in the MTU of the interface however...

@spirit LOOK THATS!! yesterday i added a new PCIe card, developed by Dell, also with intel x520-2 chipset. after added to the server, the lifecycle identified it, and an update has already appeared for download. I downloaded and installed the latest firemware by lifecycle. After upgrading, the...

10Gbyte/s or 1GBit/s

@spirit tanks. I hadn't noticed, but it also has the linux version in the intel download center. do i run this proxmox? and not in the VM, is that it?

Thank you for your help! help me again, how do I run the .exe command on linux? because this file is in .exe I download winehq, do I run the .exe for it? Do i run it proxmox?

thanks for answer the NIC Intel not from Dell so then the lifecycle does not update the firmware, I was already suspicious of that!

thank for answer the NIC card is installed, proxmox recognizes it, works on the VM in PASSTROUGH mode. however in production the board does not pass more than 2Gb / s, and the port for being 10Gb was to pass more than 2Gb / s. so I want to update the firmware of the NIC card. On the Intel...

I download driver on the intel page, but when I run the #make install command it gives an error something about the kernel version is there any other way to install the driver? I tried for life clyfe from dell, downloaded all possible drivers and firmware related to NIC Intel x520-da2, and none...

added a PCIe card, Intel X520-da2 with two 10Gbs SFP + ports My server is Dell PowerEdge. The proxmox recognized the PCIe card, everything was ok. I checked the version of my card, and this was the result: driver: ixgbe version: 5.1.0-k My question: Which driver is best for this card? How do I...

ok when i leave it on virt in CHR it is unknow, however i have not tested the network troughput, i will do that. @ermanishchawla can you help me, I went to update the network card and did not run the command #make install do I have to install build-essential to run the make install command?

I'm using the free license for now, I haven't activated the P10 yet. but, take a look at this print. CHR goes up the interface with trading at 1Gbs, not 10Gb in this print, in black is the bridge linux interface, see that it is negotiating 1Gb. Now in red is the SFP + interface, see that it is...

I'm using VM as a router, using RouterOS from Mikrotik, the CHR version made for virtualized environment. when I set up the bridge interface on the vm, if I put E1000, CHR raises the interface with 1Gps. When I leave Virtio, CHR goes up with unknown. I'm going to do a troughput test leaving...

Hi when I create a Linux Bridge, it always has a speed of 1Gbs. How do I make the speed of the linux bridge interface at 10Gbs I'm using proxmox version 6.1 it's possible?