Search results

OK. Very thanks. And last question - if I set up third node (some older hw) just for quorum. I am OK if one main nodes failed?

OK. Very thanks. And last question for interest - if I will setting up third node (some older hw) only for quorum not for VM. I am OK if one main nodes failed? Thanks and very help for your answer.

Yes it running. I used and I was able delete cluster information on first node and start VM. rm /etc/pve/corosync.conf rm /etc/corosync/* killall pmxcfs systemctl start pve-cluster But now i simulate this situation again, because I will want use 2 node cluster in my production enviroment...

I tried it before. But with same error "Cannot initialize CMAP service" :(

Hello, I have cluster with two nodes. After transfer HW servers to the new room one node stopped working (second in cluster). Now is impossible to start this node. Bad motherboard. When I start first node. No VM start. Proxmox say "waiting for quorum ..." when turning on VM. When i tryed check...

It was bad firmware in Cisco SG switch. After upgrade it is OK.

Hello. I trying connect NFS storage to proxmox. I have everywhere static IP (NAS, Proxmox, my PC) and all is connect to small cisco switch without any config. When i trying connect NFS to to proxmox didn't saw any export path and couldn't connected. But if i tryed connec NFS to the my PC, it's...

Hello, I have new HPE DL360 with proxmox and Synology NAS RS2418+. I trying migrate my VMs from backup which they are on different (old) NAS to new proxmox installation where I use iSCSI target. 1. I created LUN and Target on NAS. 2. add iSCSI to proxmox 3. add new LVM to proxmox storage...