Search results

Hello Thank you for your answer I am not able to reproduce the issue again I will close this thread

Hello, I am facing issue recently when building new VM "end kernel apnic - not syncing: attempt to kill init! exit code" image is attached

Hello, IP filter is auto generated. and it is found on the configuration. The issue appears last time after host reboot only with nftables activated. 4 servers with nftables were activated keep connected and disconnected and so on. the issue fixed by disabling the nftables. For now these 4...

What if I disabled the slaac and only keep if filtering for single assigned IPv6 then test again. Is it ok?

I Understand this point but I have other servers without this enabling IPv6 filtering and nftables behaves the same way

I disabled nftables for now. I appreciate your help.

The file is sent to you. I you need anything, please let me know

Hello, Can you provide your email to send the file to you

Hello, Here is the log as requested ###################################################### [2024-05-28T20:15:43Z DEBUG proxmox_firewall] cmd #2818 {"add":{"rule":{"family":"bridge","table":"proxmox-firewall-guests","chain":"guest-864-out","expr":[{"jump":{"target":"allow-ndp-out"}}]}}}...

I will provide it today later on because I left the office

Do I need to enable nftables firstly or only I need to run your command?

I got this in system log. so i disabled nftables ############################################### proxmox_firewall: error updating firewall rules: cannot execute nftables commandsMay 28 00:20:17 host-104 proxmox-firewall[76896]: proxmox_firewall: error updating firewall rules: cannot execute...

yes, i have that version mentioned below ii proxmox-firewall 0.4.2 amd64 Proxmox's nftables-based firewall written in rust

I found it statless. I already upgraded proxmox to up to date

i added this part manually to the configuration

Here is the installed nft version nftables v1.0.6 (Lester Gooch #5). how to get the version of proxmox-firewall?

Yes

Is it a command line?

Hello Thank you for your answer when I activate the nftables and in vm set outbound traffic for a port to block keeping the inbound of the same port to enabled, the traffic will stop. I am using nftables and firewall with default settings. while if I disabled nftables it works fine. do you know...

Hello, I would like to know if nftables is statefull or stateless?