Search results

Hi sorry to necrobump a bit, but what you describe is essentially duplicating what terraform does and slightly worse at that. Does anyone have an update on whether there is a tool to automatically provision Proxmox?

https://forum.proxmox.com/threads/pci-passthrough-qla2xxx-crashes-host.57476/post-516744 Check the link. The problem for me was that I had assigned all available memory to the VM and when I attempted to start it with a PCI device passthrough it would clash. When I reduced the memory the problem...

Not sure if this is exactly relevant to your case but I had an issue where PCI passthrough of a NIC was causing the host to crash. I had only one VM at the time on my host and I had assigned all available memory to the VM (16GB out of 16GB). As soon as the VM would start the host would crash...

After a long investigation and trying different things from the internet I finally found the solution. This happened because I had assigned all of the memory to the VM. This works fine normally but for some reason the passthrough does not like that and requires some memory for itself. Once I...

Hello, I was trying to install an OPNsense VM on a host with Proxmox. I installed it fine and then went to configure it and everything was still working. I noticed that after I added a PCI device (NIC) as passthrough the host started crashing as soon as the VM was booting which means that if...

I agree @bbgeek17 and thanks for(both) the suggestion(s). The truth of the matter is that since I did not have any significant work done on the TrueNAS only just recently installed it and no data on the HDD's it was low risk for me to go down that route.

Hello, Just installed proxmox and I want to start tinkering with it. I wanted to have a log of the mess that I am about to inflict on myself and wanted to install etckeeper. However when I try to do `etckeeper init` as root I get the error: Proxmox is on a RAID-Z1. Initial reaction was to...

I will try it, good idea. I did find a possible solution. I booted into TrueNAS and run I think glabel status (or one of camcontrol devlist, glabel list not sure right now). The output was something like: "Found GPUID in the MBR section" followed by more detailed data. However this output...

Hello, I want to install Proxmox to serve as a bare metal hypervisor to amongst other things my already installed TrueNAS. I have created a pool for my datadisks and I have an SSD which is the boot pool for it. Now I have another couple of SSD's that I would like to install Proxmox on as a...

Thank you very much for your help. One clarification, do you mean port or network interface card? Are eth0, eth1 and eth2 different ports (e.g. 3 ports of a single Intel i350 NIC or different cards (3 x Intel i350 NIC)? Sorry for being pedantic, I just find that sometimes terms are overloaded...

Hi bobmc, I am a bit confused about your confusion (so meta :p) but I am close to a noob so maybe I phrased it wrong. I have a motherboard with a Intel® i350 GbE controller (I would call this H/W NIC (Network Interface Card)) that has 4 ethernet ports. If I understand the guide correctly...

Hi, I plan to install Proxmox on my home server and then have at least 3 VM's one PFSense, one for TrueNAS and one for services. I only have the single HW NIC that comes with my motherboard that has 4 Ethernet ports. Is it possible to configure Proxmox so that the input from the Modem goes...