Thank you for the information. After some research, I found out that I can simply use a local network IP and it doesn't need to be configured at the router. I changed my IP in the Ceph configs to the new local IP.
But now I think because I couldn't finish the setup previously with the same...
Thanks for your reply, unfortunately I only have the 10.10.233.0/24 subnet available :(
And I want to use only eno49.
So I think
auto bond0
iface bond0 inet static
address 10.10.233.11/24
bond-slaves eno49
bond-mode balance-alb
bond-miimon 100[/CODE]
should be okay...
I just created two Linux bridges for Ceph and Backup. Is this incorrect?
auto lo
iface lo inet loopback
iface eno1 inet manual
iface eno2 inet manual
iface eno3 inet manual
iface eno4 inet manual
iface eno49 inet manual
iface eno50 inet manual
auto vmbr0
iface vmbr0 inet static...
I was trying to install Ceph on a new 3-node Proxmox cluster. Therefore, I created two extra network bridges for my two 10G ports. The installation of Ceph was successful. However, when I wanted to configure the public and cluster networks, I encountered the following error:
Multiple IPs for...
Hey, I have quite much trouble to install Proxmox on my PC.
Somewhere I was reading that you can install Proxmox on a VM in VirtualBox and configure it.
If it's installed on VirtualBox you just can move the preinstalled proxmox to the PC.
Can someone tell me if it's working. I couldn't find...
Hi,
Before I start I want to say, I am a beginner in Proxmox/Linux and I want to use it for learning .
When I Installed Proxmox on a new Computer I got several Errors.
1. Error
Proxmox Installation got stuck at "Starting a root shell on tty3" after a few min this Error appeared...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.