Search results

I was passing through a drive to a VM (I know I shouldnt do it this way, it is just temporary) but when I ran qm set 100 -scsi2 /dev/disk/by-id/... I got an error: file /etc/pve/storage.cfg line 8 (section 'local-lvm') - unable to parse value of 'content': invalid format - invalid content type...

So I've been running proxmox for a while now, but I just recently plugged in a monitor. It just say's the following message: "Reading all physical volumes. This may take a while...". This is an issue since I'm not able to access the CLI. How do I go about fixing this issue?

So I'm trying to enable IOMMU so I can pas trough a PCIe device. I've follow the guide from the documentation but in the GUI it still says: "No IOMMU detected, please activate it.See Documentation for further information.". When verifying if IOMMU is enabled using dmesg | grep -e DMAR -e IOMMU...

So I'm trying to install proxmox but after I select "Install Proxmox VE" It start to load but then it loads in the wrong resolution, because of this I cant see the next/continue button. I tried multiple monitors and both VGA and HDMI output's. Any help would be appreciated. Edit: I'm using...