Search results

ok, I think i have the root cause figured out ... corosync. my zfs pool is clean. PVE just hasn't started storage. I modified my corosync.conf with a additional link a few days and also updated mtu on the network that corosync uses. the node(s) may not have been fully rebooted and using all...

Lost utility power this morning and UPS drained -- no, I unfortunately (in hindsight), don't have Proxmox setup to shut the host down while on UPS. On power up of pnode-a, noticed my vms were all not started and couldn't login even with 2fa recovery code. SSH into the system, noticed there...

thanks for the write-up. this is exactly what I need with my switch recently crashing (yeah, time to replace the switch too but single switch will always have this issue). i am going to possibly try and wire the two proxmox servers directly to each other and then have the qdevice on only the...

thanks, this post help me test my disk replacement on a healthy rpool. I wish the proxmox wiki was more detailed and gave an example like this instead of just 3 lines of commands ... because I wasn't sure where to start if I was installed/booting off the rpool.

Okay, so after messing around with a bunch of things I read today, I got my error code to 43 and that may have set me on the right path to something that works. It's late here (almost midnight), I'm just going to outline what my current config is where the Ryzen igpu is being passed over...

Hey All, Somewhat new to Proxmox and trying to get iGPU passthrough working so I can use it with my blueiris VM. Looking to see if I could possibly get some help with Ryzen igpu passthrough ... maybe there is something I overlooked or did wrong? Motherboard: Gigabyte B450 Aorus M (B450M I...

Thanks, took me a bit of time to decipher your post and figure out what to do (don't work much in Linux or whatever flavor Debian is). I didn't have the eno1/2 issue you had, In my ifconfig/ip a -- post upgrade -- it seemed to have linked an alias for it when it booted up. Anyway, I'll add...