Search results

You can set the scrub load threshold [0] as the following: ceph config set osd osd_scrub_load_threshold 2.0 [0] https://docs.ceph.com/en/quincy/rados/configuration/osd-config-ref/#confval-osd_scrub_load_threshold

Hi, Yes, I can confirm that I installed the Proxmox VE on `ASUS NUC 13 Pro` and everything works smoothly.

Hi, Can you check if the Network Device inside the Windows is installed i.e., open the Device Manager and check if the Red Hat VirtIO Etherenet Adapter is installed. If yes, could you please try to set the Network to the VM to `Intel E1000`?

Could you please post the network configuration `cat /etc/netwrok/interfaces` and the output of `ip a`?

Thank you for the syslog! Could you please check the disk health using `smartctl`? smartctl -a /dev/sdb Since the `Input/output error (os error 5)` points to a hardware issue.

Can you please check the output of the `ip route` in the VM? The output should indicate your gateway `192.168.1.1`. Additionally, what say the ping to the gateway?

I would first check if the VM is already set to the `vmbr1` and check if the firewall is enabled.

Can you check the syslog for more entries? I would also try to restart the following services: systemctl restart proxmox-backup proxmox-backup-proxy

Hi, The full SMB storage impacted the pvestatd daemon, which can cause the Proxmox VE Web UI to become unresponsive. I would check the syslog around the backup time. You can also restart the pvestatd and pveproxy services.

Hi, Could you please check if that storage disks are properly connected or/and mounted?

Hi, Can you check if the NIC have an available firmware update? Sometimes the firmware update can help. and/plus check if you have microcode is installed in your Proxmox VE.

Hi, I still not have tried that. However, you can try to resolve the IPv6 on both nodes in /etc/hosts i.e., remove the IPv4 from /etc/hosts and add the IPv6.

Hi, We offer support in German and English. Please consider posting in one of these languages for quicker help! Have you managed to resolve your issue?

Hi, Can access from other device? Have you tried to ping the Proxmox VE IP?

Hi, Please post the network config of your Proxmox VE `cat /etc/network/interfaces` and the VM config `qm config <VMID>`.

Hi, During the migrate the VM faced a temporary lock issue on the replication bitmaps as you see above two lines. This can occur if another replication or backup task is holding these resources during migration. So the question is; there is a replication or backup process during the migrateion?

Hi, You have to install and enable the Qemu-Guest-Agent [0] [0] https://pve.proxmox.com/wiki/Qemu-guest-agent

Could you please post the VM config? `qm config 100`

Hi, First, I would check the syslog what to know what happened! Then check the root disk space, you can run `df -h` command to see if the `/var` or/and `/` directory is full. Did you try to restart the failed services? systemctl restart pve-cluster pveproxy pvedaemon pvestatd pvescheduler...

Hi, Do you see anything in the syslog before and after the reboot in 30~ min? FYI, you can get the syslog with specific time/date in the Proxmox VE Web UI by going to `Datacenter -> {NodeName} -> System Log` Or using journalctl CLI e.g.: journalctl --since '2024-10-04 00:00:00' --until...