Would a Ryzen 4300U mini PC with 16GB RAM be enough for a small Proxmox VE lab?

oliviagarcia

New Member
Nov 15, 2026
6
0
1
I am planning a small home lab in my Madison apartment and space is tight, so I am looking at a compact mini PC rather than a rack server. The one I keep coming back to has a Ryzen 4300U, 16GB of RAM, and room for one M.2 drive. My goal is Proxmox VE with two or three lightweight VMs plus a container or two, mostly for learning and a small file share.

What I am unsure about is the network side, since it looks like a single Ethernet port, and whether 16GB is enough once ZFS takes its share of memory. I also wonder whether the CPU will feel constrained if I add a VM with heavier I/O. I found this specification online and have no hands-on time with it.

Has anyone here run Proxmox VE on a similar low-power mini PC? I would appreciate thoughts on RAM sizing, ZFS versus ext4, and whether the single NIC became a problem.

Update after looking around more - KAMRUI Pinova P1 Mini PC Review kept coming up for the 4300U specs. I am still unsure whether 16GB leaves enough headroom with ZFS, but I am leaning toward ext4 and maybe a USB NIC for a second interface.
 
Last edited:
If you plan to build a Proxmox VE cluster in the future, having only one Ethernet port could be a limitation.

A dedicated network for Corosync is not strictly required, but separating cluster communication from other network traffic is recommended for stability.

If you only plan to use a single Proxmox VE node, however, one Ethernet port should be sufficient for your current needs.
 
On a single (homelab) node, one NIC is not a deal-breaker.
16GB RAM depends on your LXC/VM needs - as you will have approx. 14GB available.
BUT: The one single M.2 drive in my opinion is an issue. It is a SPOF & on a (cheap) mini-PC this can fail (both the drive itself & the IO on the bus). You should look for a mini-PC that can house at least one other drive, so that you have backups stored elsewhere. (USB-attached drives can be flaky).
On a mini-PC, the 321 backup policy is crucial - expect to have to reinstall EVRYTHING at some point!
 
  • Like
Reactions: Kingneutron
Look for a used Dell Optiplex Micro on Ebay. In this you can use 2 x M.2, you can expand the Mem and you will get at least with a 10th Gen i3 4+4 Cores.

You will have a lot of trouble with this unidentifyable China-Scrum.
 
  • Like
Reactions: news
That CPU is very capable. You will run out of RAM long before you over tax the CPU. 16GB is not going to be enough in my opinion. For a lab environment, one drive is a risk, but it is an acceptable risk if this is a testing environment and you can tolerate potentially losing data in a drive failure. Two drives in a mirror would be better. Single NIC doesn't bother me. I would go ZFS personally.
 
Of course everybody has a slightly different recommendation for you. My two most important cents are these:

1) always use ZFS. The idea of "ZFS eats my RAM" was an urban legend from the beginning and you would lose a lot of really great features: https://forum.proxmox.com/threads/f...y-a-few-disks-should-i-use-zfs-at-all.160037/

2) buy more RAM - even with today's crazy prices. RAM is always the resource which limits adding more VMs/Containers. ((I have suspended some machines with "only" 64 GiB Ram and got me some with 128 GiB RAM. In my Homelab. Admitting that was before the current... problem.))

Again: everyones mileage will vary...
 
  • Like
Reactions: Johannes S and news
always use ZFS
On a single-node cheap mini-PC, I think ZFS is a no-no. Except for the extra data writing involved on some crummy disk (consumer standard or below), while using an inferior bus, & some suspicious RAM, doing ZFS on a single disk without redundancy, does not make sense to me. I know my comment will probably start the whole ZFS yes/no convo going, compression, bit-rot & snapshotting, but I stand by my opinion; ZFS is a super & powerful engine, put it in an applicable car.
 
Be aware that typically only the 7000 series Dell Optiplex Micro systems have the dual NVMe slot. Others are one NVMe and almost all have one 2.5" SATA as well.

Small form factors seem cute and cool, but I would suggest avoiding them unless you absolutely have zero space for anything else. You have extremely limited upgrade options and once you want to do anything proper with Proxmox PVE, it will probably not be usable.

I'd suggest the Dell "small desktop" form factor instead, which should get you two low profile PCIe slots for faster networking or a GPU (or even both), at least one NVMe slot, 2x2.5" or 1x3.5" SATA, 4xDIMM slots (some only two, so check first), lots of front and rear ports, and lower noise due to larger fans and better CPU heatsinks.
 
  • Like
Reactions: Johannes S
That's not right, at least some of the HP 1 liter PCs have dual NVME sockets. My elite mini 800 g9 did.
 
I'm only referring to the Dell OptiPlex Micro suggestion. There are 3000/5000/7000 series chassis, and only the 7000 has dual NVMe. So if you go on eBay, just be aware of what you're looking for.