Recent content by vsp2979

Appreciate the in-deapth response, maverickws. Will give it a go and respond back. Also, very glad to hear about your experience, will try it as well.

Thank you, Correct, I have rebooted PfSense and interface config ran successfully, but as I mentioned before, I went with standard IPs of PfSense. SO I should assign 10.x.x.x. IPs for PfSense LAN, similar to my network 10.0.x.x? And what should be the WAN IP of PfSense?

Hi maverickws, I am stuck in the similar situation, wondering if you can guide and I hope OP is fine with the question. It makes sense to configure IP address on en01 interface, but where do you set WAN interface for PfSense? In PfSense interfaces or Proxmox bridges?

Hello Proxmox experts, Greetings!! have been trying to setup a homelab to tryout Virtualization and firewalls, decided to go with Proxmox and PfSense based on the popularity and active users. I was able to install Proxmox on a HP ML370 server with 4 NICs and bunch of VMs. Installed PfSense...