Recent content by vivekdelhi

Aah, Managed to Identify the issue and correct it. Its all there in the proxmox Wiki. ! Thanks If only I had looked harder earlier the /etc/pve/stodage.cfg is shared across the cluster. Since two fo teh nodes do not have ZFS, I needed to explictly specify which all nodes had ZFS. That was...

I suspect the storage.cfg needs to be amended. The current configuration is root@dell0104blade04:~# cat /etc/pve/storage.cfg dir: local path /var/lib/vz content backup,vztmpl,iso maxfiles 4 shared 0 zfspool: local-zfs pool rpool/data content...

Dear Forum Members Today I installed Proxmox on two blades. Each blade has two drives, No RAID. The Installation was done on /dev/sda, with EXT4 as the file-system. I wanted to stay away from ZFS due to memory concerns since these are low RAM servers (only 32GB) and because the second drive was...

Thanks

Thanks Alwin, Indeed this made the GUI entry disappear. Much appreciated Vivek

Hi Alwin I restarted the pvestatd service but the monitor still shows up as "?" Screenshot attached I had to restart the cluster and had expected that this would disappear but it is still persisting Any suggestions please. Thanks Again Vivek

Thanks for your reply. Here is the relevant information # ceph osd df tree ID CLASS WEIGHT REWEIGHT SIZE RAW USE DATA OMAP META AVAIL %USE VAR PGS STATUS TYPE NAME -1 1.63507 - 1.6 TiB 697 GiB 693 GiB 87 MiB 4.0 GiB 977 GiB 41.65 1.00 -...

Dear All I have a running proxmox cluster with three nodes. One hard drive of each node is part of a CEPH pool. I configured a HP blade with Smart Array p244br RAID contoller. The Raid controller was put in HBA mode and then Proxmox was installed using ZFS0 using one hard drive (600GB). The...

Thank You! After following your advice, one Ceph-mon is gone. i still have one pesky mon left. On hovering it shows up as present in dell0104blade10 while the name of the problematic mon is dell0104blade02 (Screenshot attached) root@dell0104blade10:~# ceph -s cluster: id...

Thanks Alwin ! Indeed I do see a systemd service root@dell0104blade02:/etc/systemd/system/ceph-mon.target.wants# ls -al total 10 drwxr-xr-x 2 root root 3 Sep 20 16:19 . drwxr-xr-x 14 root root 19 Sep 23 17:04 .. lrwxrwxrwx 1 root root 37 Sep 20 16:19 ceph-mon@dell0104blade02.service ->...

I am running en experimental 3 node proxmox 6 VE - Ceph hyperconverged cluster (blade01, blade02, blade10) . I had an issue with ceph versions that got corrected. However now I am seeing an issue with Monitors on the Blade02. GUI screenshot attached. I see a "?" and on hovering i get "Address...

Thank You for the suggestions. I did that now all versions are consistent

Hello All, I a just getting my feet wet with ceph and proxmox. I have set up a basic three node cluster. Each node has two HDDs, 300GB each, No RAID. The nodes have hostnames set and mapped with IPs and NTP has been set as well. On /dev/sda, Proxmox has been installed with ZFS formated...