Recent content by Trilom

Thank you for this comment, this is infact some sort of issue. If you use packer 1.6.5 no matter what disk.device you choose it will not put the disk as the default boot disk on the created VM. When using 1.6.6 as explained here, this worked without adding anything to the boot command I don't...

Given this is the case, then you are right that makes sense. My assumption was that ceph provides this by default and it was explicitly removed however the path to setting this up is very loose and this piece of information was assumed by me. I understand that even if I were to pull ceph from...

Okay this is looking a lot better. While a build attempt was firing off I tried mounting the /dev/vfio/31 device with no luck, and had to umount /dev/vfio/31 to make it go away. This was somewhat expected. Trying the ceph-volume raw prepare --bluestore command gave me the same results as...

Thank you for the link to the source, I found it just a little ago and am in the process of building OSD now with SPDK enabled and will let you know how it goes. Using ceph-volume raw prepare --bluestore --data {device} might not be a bad idea now but I'm not 100% sure. Prior to this when I...

Thank you very much for the prompt reply Alwin. Being that the flag needs to be enabled, is there a place where I can pull, enable, build and test or can you provide me a build with this enabled for testing? Their documentation is very sparse and fluid however I believe everything is in the...

Greetings, I have been fighting through trying to enable spdk with ceph and have ran into a block and I'm not sure where to go from here and was curious if your team had some input. The attempt here is to use spdk to present an nvme device to ceph. When using spdk to test the nvme device it...

Thank you very much for your notes here. I am working on using spdk with proxmox and ceph and this helped me enable vfio on my Sabrent RocketQ NVME disk attached to a HP dl160 gen8. I have a few more HP servers where these notes will apply to so I will update later if anything changes but here...