Recent content by sysadminfromhell

The Output is: root@pbs01:~# journalctl -u systemd-fsck@dev-sdb1 Nov 14 16:59:42 pbs01 systemd[1]: Starting systemd-fsck@dev-sdb1.service - File System Check on /dev/sdb1... Nov 14 16:59:42 pbs01 systemd[1]: Finished systemd-fsck@dev-sdb1.service - File System Check on /dev/sdb1. Edit: But...

The output is:

Hello everyone, the PBS should check periodic the filesystem of the Backup Store aswell as the root Disk. For the Root-Disk it works normally but I checked when the last check of the Datastore was and its 2 Years ago. Which cant be right because the periodic check is enabled todo after all 2...

Hey there, so today I noticed that sometimes a SMTP 554 is a DSN=4.0.0 for the Proxmox Mail Gateway and is handling the Mail as 400 errors. Can I somehow honor the 554 error? 2024-06-26T10:28:48.553610+02:00 mx postfix/lmtp[154285]: 2B8644095D: to=<Somerecipient>...

Hello, I reed the forum in this post "Proxmox 8 Breaks Nested Virtualization", but didn`t see any conclusion/solution so far. Is there a fix yet? I upgraded a few days ago to PVE8.2.2 with the last recent kernel "6.8.4-2-pve" but still no luck. I wanted to allow a user to use docker but docker...

Update: Version 1.1 is out which is pushed for the plattforms arm64, armv7 and amd64 to your liking aswell as a Ubuntu deviant if you want to use ubuntu instead of Debian. The Version string for debian is fixed to a certain one. No changes inside of the image. The Build parameters are also using...

Hello everyone, I was facing the problem with a Two-Node Cluster that they sometimes misbehave in some way so I used a old Rasperry Pi 4 which was great until it wasn`t. For a shared storage between the two nodes I use an QNAP NAS directly attached which works greate as a storage. On the NAS...

Nevermind, I foudn a fix, todo systemctl stop pve-ha-crm.service && rm -f /etc/pve/ha/manager_status && systemctl start pve-ha-crm.service on all nodes at the same time.

Ah yes before I did a pvecm delnode "dead" and then after the fresh install (about 1 or 2 hours) a pvecm add

Hello everyone, so a few days ago the electricity failed in my homeoffice and the small homelab for Home purposes failed. One node was complelty failing until the point the ssd inside was basically dead. It could boot, sometimes but after a few minutes went offline again due I/O error. I came...

Hello everyone, maybe this question got asked somewhere but I couldnt find it: Is it possible to remove the HA functunality and use the cluster only as config cluster? So that the information about Storage user etc. are shared but no HA so I can turn on/off hosts if needed? Kind regards,

For me its super weird because I have 2 identical Nucs, same model: 10th Gen i7 same Intel Nic. (Intel NUC10FNH) One has this problems and can only be fixed if I disabled the tso, gso and gro, I installed the permanent fix in the /etc/network/interfaces file and see if this will help...

HEre u can see for yourself: I mean yesterday I had roughly about 800G usage, but I had to move one disk (500G) to another LUN. So therefore its fine by me now but also here I have the same problem: I guess the compression makes it more small but this also means that the Proxmox hosts...

pct rescan didnt change the usage of the volumes / LVMs

I mean its a service option to enable these features, I really "didnt" rescan the device how can I do that via CLI then? Properly setup? its not zfs infact its a RAID10 (6 HDDs) with RAID0 Cache (2 M2 SSDs). In the NAS its properly I guess ...