Suspect an issue here for sure. Laid out this configuration from /etc/network/interfaces:
auto lo
iface lo inet loopback
auto enp6s0f1
iface enp6s0f1 inet manual
auto ens1f1
iface ens1f1 inet manual
auto ens1f0
iface ens1f0 inet static
address 192.168.50.3/29
gateway 192.168.50.1...
Good day. Currently using l3 switches in the environment (ubiquity flex switcehs). Trying to setup proxmox with a management port, and a bond. Looking for advice on the best method.
Currently I have 4 network strands going into the proxmox rack server, 2 per vlan. VLAN 50 (mgmt) and VLAN 30...
All cables connect to GB switch, go through wall, and plug into internet router. So attempting to virtualize server, and have DHCP run on LAN interface only (with no bleed-over).
Networking reconfigured as:
* vmbr5 => ip for WAN (comment in that this wan port)
* vmbr0 => bond0 (bond0...
Good day. I have a home rack-mount server that has 5 or 6 eth 1G ports in it. I was looking at setting up proxmox to play around with VMs, probably some docker containers and some kali type stuff for pen-testing. The first VM I was looking at installing is pfsense.
I was looking at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.