Recent content by pablomart81

Hi everyone, I found this thread https://forum.proxmox.com/threads/iperf-testing-with-lots-of-retransmissions.95553/ Changing MTU size from 1500 to 9000 seems to solve this problem. Before doing this check that your network infrastructure supports MTU size bigger than standard 1500

Hello everyone, We have been doing some network testing on our VMs because of a recent network change we have made. While doing this test we have noticed a high retransmission rate on our VMs, between nodes. This doesn't happen when VM's are on the same node, or when we test between 2 pve...

I have made an enquiry with HP, the servers are HP and we pay for hardware support. It seems that the latest firmware version they have installed has generated problems with the hardware, fans running out of control, network cards that do not work correctly and disk control problems, which I...

Does anyone know what this log is due to and how it affects the functioning of Ceph? Aug 26 07:46:03 pve01-poz kernel: libceph: osd10 (1)10.0.0.1:6827 socket closed (con state OPEN) Aug 26 07:47:35 pve01-poz kernel: libceph: osd10 (1)10.0.0.1:6827 socket closed (con state OPEN) Aug 26...

of course, attached file The creation of the .chunk is clearly visible.

Does anyone know what this log is due to and how it affects the functioning of Ceph? Aug 26 07:46:03 pve01-poz kernel: libceph: osd10 (1)10.0.0.1:6827 socket closed (con state OPEN) Aug 26 07:47:35 pve01-poz kernel: libceph: osd10 (1)10.0.0.1:6827 socket closed (con state OPEN) Aug 26...

I created it because it didn't create itself. I set the permissions to backup:backup but no directories are created inside it. What I did was create a data store inside it, everything was created correctly. thanks

Hello, When I try to backup my PVE to the PBS STORAGE I get this error ERROR: VM 101 qmp command 'backup' failed - backup register image failed: command error: inserting chunk on store 'STORAGE' failed for bb9f8df61474d25e71fa00722318cd387396ca1736605e1248821cc0de3d3af8 - mkstemp...

Thank you for the prompt response, The problem is on two servers, 2 and 3, each of them has 2 degraded network cards. Thank you very much

Since we upgraded to version 18.2.2, the cluster is noticeably slow, when removing a disk it takes a whole day to return to a "health ok" state So that you understand the architecture a little, I have 3 identical servers with 2 sockets of 24 cores and two threads, 512G ram, 6 2TB sas disks for...

Flapping a network interface linked to corosync can generate this behavior, causing the entire cluster to reset????

In relation to the modification of corosync, I have seen the documentation that you have provided me, it is very easy to make the change, thank you very much

I have these TOTEM Messages, I understand that these are only notification messages. May 30 10:40:40 pve01-boa corosync[2465]: [TOTEM ] Retransmit List: b6a93 May 30 10:40:40 pve01-boa corosync[2465]: [TOTEM ] Retransmit List: b6a95 May 30 10:40:41 pve01-boa corosync[2465]: [TOTEM ]...

Thanks Chris I will take a look at the docu to modify the corosync network One more question, all TOTEM notices due to corosync connectivity failures?

there are 2 links of 10GB According to what you indicate, I should remake the entire cluster This is impossible without a very high service interruption