Recent content by justlookingaround12

Clearing the browser cookies did the trick! I'm completely new with Proxmox (probably unrelated), sorry for wasting your time and thank you for the help!

Large output attached, what i think is the answer: proxmox-ve: 5.1-42 (running kernel: 4.13.16-1-pve) pve-manager: 5.1-46 (running version: 5.1-46/ae8241d4)

So i backed up my LXC container and moved it over to a fresh install. Now, when i look at the summary i don't get a used % of the boot disk (screenshot attached). I don't know if I'm just imagining, but I'm almost certain that i used to get a used percentage (so like 2 GB out of 8 GB used...

That gets me one step closer, with your advice a blank page loads, but with the correct title (pve ....). Any ideas past this?

So I'm trying to get reverse proxy working. I can get it to work with https://subdomain.domain.com, however i can't get it to work with https://domain.com/subdir (or https://subdomain.domain.com/subdir for that matter). Any idea what i have to change in the NGINX config? My location block is...

Is there a reason that the containers get locked? I don't believe i actively locked any and i was facing the same 'problem' (same fix as well). Any way to avoid locking as well?

Thank you all for your replies, I had to travel for work so i wasn't in to check anything until today! @fabian 's answer worked perfectly, thanks again.

Initially i created my RAID through intels software at boot. That didn't work. Then I did it in the installation process. That worked but obviously the system was broken (no web access and repeated rpool mounting issues )

So i tried to make my first LXC container, got the ubuntu 16.04 image from Proxmox. When i try to start it it give me this: Job for pve-container@101.service failed because the control process exited with error code. See "systemctl status pve-container@101.service" and "journalctl -xe" for...

It wasn't working. I did a fresh install again, no RAID (again) and now it seems to be working just fine. Not eager to go back and try a fresh RAID install..

Did a quick install on one of the remaining hard drives that aren't on the RAID system.. still no webgui. Not sure what's happening.. Nope, just checked as well just to make sure.

Is that with regards to the broken boot or no webgui access? thanks