well, we changed CPU, now the VM cannot start..
kvm: -device vfio-pci,host=0000:0c:01.0,id=hostpci0,bus=pci.0,addr=0x10: vfio 0000:0c:01.0: Failed to set up TRIGGER eventfd signaling for interrupt INTX-0: VFIO_DEVICE_SET_IRQS failure: Device or resource busy
TASK ERROR: start failed: QEMU...
hello all,
trying to activate IOMMU, to passthrough a pci card to a host.
upgraded to Virtual Environment 8.1.4
my motherboard:
dmidecode -t 2
# dmidecode 3.4
Getting SMBIOS data from sysfs.
SMBIOS 2.6 present.
Handle 0x0002, DMI type 2, 15 bytes
Base Board Information
Manufacturer...
i finally found that it was trying to renew letsencrypt certificates, there was a false host name in apache conf and after failure, it was rebooting..
it had certbot installed both with apt and snap.
removed all, installed through snap and now its not rebooting.
thanks for pointing me to syslog.
hello all,
i have several proxmox servers, in a specific one, i run a Debian 11 VM.
this VM reboots randomly..
reboot system boot 5.10.0-19-amd64 Tue Oct 25 00:24 still running
reboot system boot 5.10.0-19-amd64 Mon Oct 24 22:08 - 00:23 (02:15)
reboot system boot 5.10.0-19-amd64...
hello all,
I want your opinion, what to choose, a VM or an LXC Container for running only nginx ?
I only want to run nginx, on a secret port, to stream some cameras and allow users to view..
So, can i do it with an LXC Container ?
If not, which linux distro you suggest as lightweight, etc.. ?
I can second this.
I have an ML110 Gen 7, with a 512mb SSD and 5 2Tb sata disks.
Restoring was lasting for ever.
I set the controller to Raid mode, create a logical drive with one disk (the ssd) and Proxmox booted normally..
and of course restoring/moving hosts now is very very fast...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.