I was passing through a drive to a VM (I know I shouldnt do it this way, it is just temporary) but when I ran qm set 100 -scsi2 /dev/disk/by-id/... I got an error:
file /etc/pve/storage.cfg line 8 (section 'local-lvm') - unable to parse value of 'content': invalid format - invalid content type...
So I've been running proxmox for a while now, but I just recently plugged in a monitor. It just say's the following message: "Reading all physical volumes. This may take a while...". This is an issue since I'm not able to access the CLI. How do I go about fixing this issue?
Thanks, however this didn't fix the issue :(. When trying to boot a VM with the HBA passed through I still get the following error
TASK ERROR: IOMMU not present
Yeah, I tried that before but I got an error, same now:
root@server:~# apt-get update && apt-get dist-upgrade
Hit:1 http://security.debian.org buster/updates InRelease
Hit:2 http://ftp.nl.debian.org/debian buster InRelease
Get:3 http://ftp.nl.debian.org/debian...
Ok, my CPU supports VT-d for sure, my motherboard I'm not sure about. I already have VM's working so they both must at least support VT-x :).
After I run:
for d in /sys/kernel/iommu_groups/*/devices/*; do n=${d#*/iommu_groups/*}; n=${n%%/*}; printf 'IOMMU group %s ' "$n"; lspci -nns "${d##*/}"...
My CPU support VT-x, and with my MB I couldn't find any information about it. But I don't really need groups, I just want to past through the complete PCIe device. But when I try I get the error that IOMMU isnt activated.
What I'd like to do is instead of passing through 6 individual Hard...
So I'm trying to enable IOMMU so I can pas trough a PCIe device. I've follow the guide from the documentation but in the GUI it still says: "No IOMMU detected, please activate it.See Documentation for further information.".
When verifying if IOMMU is enabled using dmesg | grep -e DMAR -e IOMMU...
I tried a different USB stick on a different port, but I got the same issue
The sum is: 5a1becb95ebc48e6eafeb9fa704d1025b8c35dfa1ba28c533dc2ebf15d0a039b *proxmox-ve_6.3-1.iso
So the sum is the same.
No error's during loads
I'm using 2 Xeon E5-2660's and an old AMD GPU (I think the AMD HD 6570)
I already managed to install proxmox using ALT+G, ALT+N and ALT+I.
Any help fixing this issue would still be appreciated
So I'm trying to install proxmox but after I select "Install Proxmox VE" It start to load but then it loads in the wrong resolution, because of this I cant see the next/continue button. I tried multiple monitors and both VGA and HDMI output's. Any help would be appreciated.
Edit: I'm using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.