Recent content by eset

I can share you terraform code with you

@jsterr And did you done something according to the issue?

btw I got this to. After I struggle with not working tf code on PVE8 that removes cloudinit with cicustom I break the process and run again and then I get cloudinit back again plus it does this thing above and it does it over and over constantly every time I launch plan. What was the solution ?

Yeah of course. I have already prepared whole setup for two scenarios. For use pve with terraform indeed we need template so I also have created ansible scripts that creates templates instead of manually putting `qm` commands in CLI. It also used some conditional to avoid issues with lack of...

I don't wanna create new post here, but did someone had problems with Terraform provider https://registry.terraform.io/providers/Telmate/proxmox/latest/docs from Telmate? There is serious debate going on on https://github.com/Telmate/terraform-provider-proxmox/issues related with that provider...

You can check previous posts a made some charts how I use that with Mikrotik , my Lan network and SDN on Proxmox with VMs

I really had that. GUI applied those two addresses and config under CLI when checking the file had only one IP. Yes, I did `Apply` in GUI. Fuck it. The setup works inn BGP so no need to investigate any further. I can confirm MikroTik and SDN with EVPN controller and additional BGP.

I mean it's possible through /etc/pve/sdn/zone.cfg to remove the exit node. That's strange because for controller even if I setup 10.0.1.30,10.0.1.1 like this I only see there, in controller.cfg 10.0.1.1 IP without 10.0.1.30. Only the previous setup works with BGP announcment, exit nodes...

I wonder how should those peers in even controller set. With comma or something? Could be parsed into documentation because when adding like that I should see in /etc/network/interfaces.d/sdn ? Strange because non of settings with EVPN only (Without BGP controller) doesn't work or I don't...

And I'm confused each time @spirit when you mention this: in evpn zone, don't configure exit-node. (as it'll be your vyos). but that's impossible ! It always force the Primary Exit Node, take a look on screenshot.

@spirit Btw I upgraded my routeros6 to routeros7 that supports EVPN and VXLAN. But You mention to set exit nodes instead proxmox nodes.. but how? When that field in proxmox settings for the ZONE doesn't accept any value that proxmox node , so how can I put there something else?

The same problem here @spirit when I was changing network setup according to your recommendation for SDN almost exactly like here by moving vlan from vmbr0 to bond0 I have the same issue with gateway.

That obvious. But I wasn't able to remove even without gateway. There wasn't even a gateway added at all. Second @spirit there is issue with VLAN on Bonding I attached my answer to this topic because I have the same issue like this user...

Ok if it comes to MetalLB I managed to deal with by loosing 10.0.50.0/24 network and set 10.0.10.128/25 which is the part of 10.0.10.0/24 that already works because of the SDN troubleshooting part and that works :)

@spirit Hm but from What I achieved it seems like I’m so close to get this done and working. Maybe it’s firewall rule ? Btw you think that upgrading mikrotik to v7 with even support will resolve those problems ? btw @spirit Why can't I remove a unnecessary VNET I had that issue always when a...