Recent content by daniel.b

  1. D

    [SOLVED] After 8.1.3 upgrade Summary Graphs are blank

    Resolved without disabling IPv6 on Synology I experienced this problem after upgrading my 3 node cluster from 7.4 to 8.2.4. I also have a Synology storage device connected via iSCSI and was experiencing symptoms exactly as described by others, with intermittent (mostly non-functional) graphs...
  2. D

    [SOLVED] Can't add LVM on top of iSCSI: device already used by volume group unknown

    Thanks for your quick reply. Setting up multipath on all cluster nodes did the trick and I was immediately able to add an LVM on my iSCSI storage. Thanks for the tip!
  3. D

    [SOLVED] Can't add LVM on top of iSCSI: device already used by volume group unknown

    I'm attempting to configure a Synology UC3200 as an iSCSI target for my proxmox cluster. The Synology is a dual controller HA setup with an active/active setup. I have created 2 iSCSI targets and 2 LUNs on the Synology device and have permissions set to allow all. I have successfully created...
  4. D

    [SOLVED] New install of PVE7 - Bridge won't receive an IPv6 Auto Configured Address

    That did the trick! When I installed ifupdown, ifupdown2 was removed. I rebooted the node and had an IPv6 address on the bridge. Thanks for your help!
  5. D

    [SOLVED] New install of PVE7 - Bridge won't receive an IPv6 Auto Configured Address

    I have a fresh install of PVE7. I joined this node to an existing cluster which I upgraded from V6 to V7. The network configuration is default on the new node. The bridge receives an IPv4 address, but will not receive an IPv6 address from auto configuration. The other nodes in the cluster...
See more
Top Bottom
Back