Hi,
I really stuck and really need help. I have 6 nodes that runs into productions. The VMs works fine and there is problem with the proxmox nodes and cluster.
Suddenly 1 of my node got problem and it shows X in the gui. last few weeks, I join cluster by using the different fingerprint which...
HI,
I have confusion and questions here.
I have 5 Nodes that runs under production that already join cluster to Node-01 and IP is 10.0.0.1
- Node-01 - 10.0.0.1
- Node-02 - 10.0.0.2
- Node-03 - 10.0.0.3
- Node-05 - 10.0.0.5
- Node-06 - 10.0.0.6
Now I am in a midst, I have another server and...
Hi,
I already update the firmware to the latest version and I did try and still no luck.
Anyone can advise what should i do?
6: enp129s0f0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
link/ether XX:XX:XXXX:XX:XX brd ff:ff:ff:ff:ff:ff
inet...
Hi,
Good day to you.
I have 6 nodes. 5 nodes connected into a cluster and 1 node is not yet conected to cluster because I have problem with the fiber connection. 5 nodes are using Proxmox 7.1-7 and 1 node node is using 7.2-3 ( the latest version )
I did install ethtool on all 6 nodes and I...
Hi,
If I plan to use the same name ( Node-01 ) with a fresh and new server and higher spec, should i follow
5.5. Remove a Cluster Node or 5.5.1. Separate a Node Without Reinstalling ?
Please help
Hi,
Means If I remove the Node-01 and install proxmox to a fresh and new server and using Node-01 as a computer name and join the cluster at Node-02 or Node-03, is it possible?
Hi,
In my case, how about if I replace the Node-01 ( Node-02 and Node-03 join the cluster using the Node-01 information ) to a new server, is it possible? And can I used the Steps that you provide? How about the Joint Information and Fingerprint?
Hi,
I have questions here. Apparently I have 3 Nodes with cluster
- Node-01
- Node-02
- Node-03
I create cluster name at the Node-01.
Node-02 and Node-03 Join Cluster to Node-01 so the keyprint is based on the Node-01
Now I am having super problem which means I need to remove the Physical...
Hi,
Yesterday my SFP+ is working.
I just formatted my proxmox server and try to use zfd ( RAID 1 ) and my networking for X710 is not working at all.
Anyone can help me? I am not familiar with the CLI.
Please help
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.