Recent content by cj_duke

Works, thank you very much.

Dear all, apologies for bringing this thread up again. I'm setting up a container (ubuntu-20.04) with a specific network setup, therefore I would like to use .pve-ignore on the network config of the container. Unfortunately /etc/network/.pve-ignore.interfaces does not seem to work with...

Thanks Ricardo for your input. Tested WOL with the ASUS/Realtek NIC, no success. I use a PCI adapater as well for link aggregation, WOL works on this one (for testing, no bonding used) ethtool outputs: root@pve: lspci 04:06.0 Ethernet controller: D-Link System Inc DGE-528T Gigabit Ethernet...

Update 1: Tracked the issue down to the graphics card MSI R5770 Hawk. Removed the card, kernel 5.0.21-5 works, now using onboard HD4290 GPU. (Yes, I am aware R5770 is overkill for the system)

Hi all, after upgrading to pve-kernel 5.0.21-5-pve reboot/shutdown not working correctly. cli (via ssh) -> shutdown/reboot ends in state where the system should either poweroff or reboot, but nothing happens, only hard reset possible. The state describes as blank monitor without signal, no...