Recent content by bandzior

ifreload -a is the key. I didn't know that command because I didn't have to use it before. BTW I didn't change anything in the configuration. Thank you very much!

Hello. I have an issue with LACP enabled connection with two physical Ethernet cards, which means that every time I restart the connection using the command: systemctl restart networking.service It takes 30 seconds to reconnect. In dmesg after every restart I see the following logs: [Tue Aug...

I am in the middle of adding new 6 volumes to the cluster. On first node I see: /dev/mapper/VOL-10-25TB-F350 lvm2 --- 25.00t 25.00t /dev/mapper/VOL-11-25TB-F350 lvm2 --- 25.00t 25.00t /dev/mapper/VOL-12-25TB-F350...

In my first message in this topic, I forgot to add pvscan and vgscan command on all nodes. pvscan and vgscan on all nodes are showing new volumes but pvshow and vgshow are not showing new volumes besides of first node. I think that in this case I should restart udev but my procedure for other...

Next week I will have to add some volumes to cluster and will check what is happening and will let you know. Regards, Daniel

1 - Do the raw LUNs show up in lsblk and/or lsscsi output on each node I didn't check that. I will check it out tomorrow. I assume that yes because i can see new block devices under "multipat -ll" 2. Does "multipath -ll" show proper devices? Yes 3. Are there any pertinent logs in "dmesg"...

Hello. What is the proper way to add volume from FC/SCSI storage array to Proxmox cluster? I have issue that after "rescan-scsi-bus.sh" command on all nodes, making an alias in multipathd.conf on all nodes, creating PV, VG and proper definition in storage.cfg on one cluster node, i have to...

Thx for your help!

Are you saying that i can have coherent cluster with 7.1 and 7.4 nodes?

I have four nodes cluster in which there is no free space to make safe upgrade to 8. Firstly i want to exapnd that cluster and make upgrade to 8. Regards, Daniel

Hello. I'm looking for 7.1-7 ISO of VE. From where can i download it? Thx. Regards, Daniel

I have found post on linux kernel list to change behaviour of LVM by adding to lvm.conf: udev_sync = 0 udev_rules = 0 IMHO it is not safe. Best Daniel

After 20 minutes, looks the same. Best

Hello. I have four node cluster made with Proxmox 7.1-7 and i have noticed that on one machine i have errors during boot process - details in the attachment. I waited several minutes and it doesn't seem like the machine wants to get up. Any idea what can be wrong? Best Daniel

Even if I try to do: pvecm expected 1 i have the following error: Unable to set expected votes: CS_ERR_INVALID_PARAM