Ich hatte mittlerweile schon die VMs erstellt, auf Basis der Vorlage, die ich auch noch davor außerhalb der Domain erstellt hatte (die hatte ich vorhin vergessen gehabt ;-) )
Das Template war erstellt worden ala:
VM aus Domain entfernt, IP per...
Ok, die Info war gut. Das iSCSI sieht sauber aus.
Wenn du lokal auch solche Latenzen hast, tippe ich mal auf CPU Warteschlange.
Was zeigt denn der Host im Summary bei I/O Delay an? Sollte im Normalfall bei 0,x liegen und bei über 5 sollte man...
Thanks for taking a look. No zpool impot does not work without re-writing the GPT
root@pve-1:~# zpool status -vP
no pools available
root@pve-1:~#
root@pve-1:~#
root@pve-1:~# zpool status -vPL
no pools available
root@pve-1:~#
root@pve-1:~#...
I would think the steps are the same as troubleshooting any generic slow application whose job is to transfer data:
- record/analyze CPU load on both side
- record/analyze disk load
- record/analyze network load, errors
You may want to install...
Jo, der aber aber begrenzt durch die Größe der Platte.
Ich fange an zu philosophieren: Aber wenn man CIFS- und NFS-Speicher mit einem lokalen Cache haben könnte.... Oder Remote-PBS-Datastores mit Cache als Tape-Job wählen könnte...
Wie auch...
Kurzes Feedback: Joa, könnte wohl so bleiben. Habe den Share von Standort A mit nconnect=16 an C angebunden. Der Sync ging flott, und das Tape-Backup schiebt er gerade auch mit ~300MB/sek aufs Tape. Das ist ziemlich genau was das Tape Drive auch...
To clarify:
The issue is not that a slow backup stalles a VM. It’s rather that sometimes backups take forever for seemingly no reason.
Involved storage: Local ZFS mirrors.
Ich hatte mittlerweile schon die VMs erstellt, auf Basis der Vorlage, die ich auch noch davor außerhalb der Domain erstellt hatte (die hatte ich vorhin vergessen gehabt ;-) )
Das Template war erstellt worden ala:
VM aus Domain entfernt, IP per...
Nicht zu kompliziert denken.
Theoretisch kannst du auch eingeschaltet klonen, aber sauberer ist das natürlich ausgeschaltet.
Die neue VM vom Netzwerk trennen vor dem einschalten (haken raus bei der NIC)
Sysprep OOB ausführen, dann ist die VM...
Wie ich es machen würde:
VM herunterfahren und Backup erstellen.
In der Config - Netzwerk auf disconnect (erweitert ; trennen) ändern.
VM hochfahren mit einem lokalen Account anmelden, aus der Domäne nehmen (wichtig ohne verbundenes Netzwerk!)...
Hi,
We have seen multiple cases of oddly slow backups that end up sabotaging the VMs (stalling them to death).
It happens across various constellations, locations and PBS versions. It’s not exactly deterministic, but there’s one server where it...
You can try this wiki to either change the password or debug the logs on you system:
https://pve.proxmox.com/wiki/Root_Password_Reset
Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox
Kurzes Feedback: Joa, könnte wohl so bleiben. Habe den Share von Standort A mit nconnect=16 an C angebunden. Der Sync ging flott, und das Tape-Backup schiebt er gerade auch mit ~300MB/sek aufs Tape. Das ist ziemlich genau was das Tape Drive auch...
I don't think there is one for this conversion.
I believe this is your only path.
Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox
You can try this wiki to either change the password or debug the logs on you system:
https://pve.proxmox.com/wiki/Root_Password_Reset
Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox
Hi @NateNate ,
You have not shared your exact configuration of either the networking or the PVE storage subsystem. If my understanding of your description is correct, you are specifying an IP address in storage.cfg:
- if you use the mgmt, the...