Latest activity
-
bbgeek17 replied to the thread Destination VM Disk after cancelled disk migration.Great, feel free to mark this thread as SOLVED by editing the first post and selecting the appropriate prefix from the subject dropdown. Cheers Blockbridge : Ultra low latency all-NVME shared storage for Proxmox -... -
bbgeek17 reacted to F4R's post in the thread Destination VM Disk after cancelled disk migration with
Like.
Hello, Thank you. This worked, I was afraid this command could stop the VM. -
FF4R replied to the thread Destination VM Disk after cancelled disk migration.Hello, Thank you. This worked, I was afraid this command could stop the VM.
-
OIf someone is submitting a request via API they might as well use API to query the task status ;-) pvesh get /nodes/$NODE/tasks --output-format json| jq -r '[.[] | select(.type == "clusterjoin")] | sort_by(.endtime) | .[-1] | .status'...
-
Iivenae replied to the thread whitelist problem.Asterisk is the english word for the star-symbol [ * ]. As far as i know: If you chose "add domain" or "add email" you cannot use any wildcard (asterisk symbol) at all. You can only enter text "as is", character by character. If you chose...
-
OOnslow replied to the thread No web GUI after upgrade from 9.0.11 to 9.1.6.@Charrat , I seem to remember that in similar cases, harmful repositories occurred to be added by these khe-khe-...helper scripts. So just in case, check what is below /etc/apt/
-
Wwhydoentitwork replied to the thread [SOLVED] Proxmox VM combining tagged and untagged VLAN traffic (host behind Unifi switch).I am not entirely sure what you mean, but here's my setup: I set up two VMs with each one NIC with VLAN ID 11 and one NIC with VLAN ID 22. VLAN IDs 11 and 22 are not used anywhere else in my network and thus should also not be allowed by the...
-
Iinformant replied to the thread whitelist problem.sorry but proxmox mail gateway show in specs and manual not regex only *@domain.tld and *.domain.tld and ... where is information that i must use coding regex here? and what you mean with asterisk, pmg is not asterisk.
-
Mmhentrich posted the thread Conntrack leaving traffic up for a long time in Proxmox VE: Networking and Firewall.Apologize if this is a dumb or often asked question, I'm just now experimenting with Proxmox firewalls. I noticed that if I enable a rule on a VM firewall that, say, allows ICMP, I'm able to ping it pretty quickly, but if I disable that rule...
-
BBu66as replied to the thread Proxmox läuft nach Stromausfall nicht mehr.Vom Screenshot her sieht serverseitig alles gut aus, pveproxy läuft und die IP auf vmbr0 stimmt. @ThoSo hat die richtigen Fragen schon gestellt. Ganz wichtig: du musst die Adresse mit https:// aufrufen, also https://192.168.178.57:8006. Ohne das...
-
Ssgw replied to the thread OCFS2(unsupported): Frage zu Belegung.# lsblk -D /dev/mapper/msa2060_lun1 NAME DISC-ALN DISC-GRAN DISC-MAX DISC-ZERO msa2060_lun1 0 32M 2G 0 Weiteres morgen oder so ... ich muss jetzt aus dem office, danke schönen Abend
-
Sstrombringer reacted to chrullrich's post in the thread DHCP race with interface configuration during automated installation with Like.
Found it, but cannot fix it. I have no idea how to keep the booting installer from briefly shutting down the interface, but my estimate of ten seconds wait time in dhclient was spot on. That value is configured in /etc/dhcp/dhclient.conf...
-
bbgeek17 replied to the thread Destination VM Disk after cancelled disk migration.Hi @F4R , welcome to the forum. You need to "qm disk rescan --vmid 100" to bring the disk into VM configuration as "unused0". Then you can remove it from the VM hardware page. Blockbridge : Ultra low latency all-NVME shared storage for Proxmox...
-
Wwhydoentitwork reacted to shanreich's post in the thread [SOLVED] Proxmox VM combining tagged and untagged VLAN traffic (host behind Unifi switch) with Like.
Can you post your network configuration on the affected host as well as the VM configuration of an affected VM? Preferably when the system is in the erroneous state: cat /etc/network/interfaces cat /etc/network/interfaces.d/sdn ip a qm config...
-
Wwhydoentitwork reacted to ce3rd's post in the thread [SOLVED] Proxmox VM combining tagged and untagged VLAN traffic (host behind Unifi switch) with Like.
hi, just tried alma VM with 2 tagged nics - worked like it should alma -> pve host -> hp switch with tagged vlans -> another pve host -> vm [root@localhost ~]# ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group...
-
Wwhydoentitwork replied to the thread [SOLVED] Proxmox VM combining tagged and untagged VLAN traffic (host behind Unifi switch).Yesterday, I changed my proxmox network configuration before I got your response. I did this because I read online that it is not good practice to have a proxmox PVID that is not equal the native unifi swtich port's VLAN ID. If I am understanding...
-
FF4R posted the thread Destination VM Disk after cancelled disk migration in Proxmox VE: Installation and configuration.Hello, I did a disk migration from local-lvm to a ZFS pool (pool-ssd) but cancelled while doing the migration (shame on me). Now I have the VM Disk in the local-lvm and my ZFS pool, VM is working fine using the local-lvm disk but I can't delete...
-
-
PHello, For several days I have been trying to use the PBS API to perform a selective re-verify for snapshots whose verify status is expiring. However, due to processing constraints, we will not be able to run this every day as mentioned in my...
-
PPuliper reacted to Impact's post in the thread Do you need to shutdown VMs to backup them with stop mode? with Like.
Is there a specific reason you use stop mode?
-
BBu66as replied to the thread OCFS2(unsupported): Frage zu Belegung.Wenn im CLI Guide auch nix zu UNMAP/zero-detect steht, würd ich an der Stelle HPE-Support kontaktieren. Das Problem sitzt definitiv im Controller, fstrim schickt die UNMAPs raus (deshalb die "freed"-Meldung), aber der Controller setzt sie nicht...
